1933-35 Dodge Steel Rubber coated Running Boards
1933-35 Dodge Pickup or 1933 Plymouth PD 112 inch wheelbase.
The running boards pictured are for 33 Plymouth PD or 1933 Dodge DP 112 inch Wheelbase. These also fit 33-35 Dodge Pickup. Specifcations on Boards:
- 16 Gauge Steel
- New Urethane - Two Part Epoxy Rubber (Modern materials - will not crack like old rubber/or NOS mats)
- Warrantied to fit original manufurers specs
- Rubber is vulcanized to boards
- Brackets align/fit original running board braces/frames
- Boards are not drilled - buyers can align and drill proper holes to align with their fenders
- The cost is prohibtive to stamp the original design in metal boards. The boards are smooth underneath (has stiffners/braces shown in pictures). They match 100% on top where rubber/boards show. If you have original boards we can cover these if you would like with new rubber.
- Models are listed below (Wheelbase is listed to verify correct boards/model). Wheelbase is measurement from center of front axle to center of rear axle.
-
Price: 625.0
-
Rear mounts brackets used with frames without leaf springs price for each pair check front or rear or bothPrice: 290.0
-
Price: 0.0
-
Outside Edge 55", Inside Edge 53", Front is 13-1/4" Wide, Rear is 8-1/2" WidePrice: 775.0