Our frames are produced from heavy gauge steel and double welded for superior strength. Full length boxing plates and our tubular cross member is installed. The cross member is designed to accommodate all short tail shaft G.M. transmissions, including the overdrive models, and other Mopar or Ford transmissions. Front radiator mounting cross member, body mounts,running board brace holes and G.M. transmission mounts can be provided. Our frame is the same design as the original frame .
They can be narrowed in the rear to allow for larger tires. Additional cost involved.
The frame shown in the main picture has our Mustang ii front IFS with power steering rack and Viking 18 position Coil Overs and Ford 9" rear end with our paralell 4 bar setup and Viking 18 position coil overs.
Note pictures are of rolling chassis and do not represent bare frame.
They can be narrowed in the rear to allow for larger tires. Additional cost involved.
The frame shown in the main picture has our Mustang ii front IFS with power steering rack and Viking 18 position Coil Overs and Ford 9" rear end with our paralell 4 bar setup and Viking 18 position coil overs.
Note pictures are of rolling chassis and do not represent bare frame.
This item is also in the following categories:
